Table of Contents
Advertisement
A.11 Recalibrate The Touch Screen Of VP-25W7
The touch screen has function with the default calibration. It is necessary to calibrate your screen
when it works not precise.
The calibration process is different from the PCB version, so before starting the calibration process, you
must first check with the PCB version, as follows:
The latest version - PCB 1.7 or later
If your PCB version is 1.7 or later, there is a rev
number sticker between the I/O slots.
After checking the PCB version, then select the calibration process that corresponds to your PCB version.
The latest version (PCB 1.7 or later)
1) Run the Touch_calibrate
ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
The earlier version - PCB 1.5
If your PCB version is 1.5, there is no rev number
sticker between the I/O slots.
The earlier version (PCB 1.5)
1) Open the Control Panel
Ap-11
Advertisement
Table of Contents
