ICP DAS USA ISaGRAF WinCE ViewPAC User Manual page 182

3. Then run "Network and Dial-up Connections" as the figure in the next page to set "8135" Ethernet
port to a fixed IP address. (ISaGRAF PAC can use only fixed IP, no DHCP). Then remember to run
ViewPAC utility to "Save and Reboot" once to save the settings.
Note:
1. ViewPAC 's Ebus is working on its first Ethernet port – the "LAN1". This is un-like the WinPAC-8xx7
which is working on its "LAN2".
2. When program the "RDN_new" in VP-25W7/23W7/25W6/23W6/4137/4136, it is necessary to install
the "I-8135W" in slot 0 and enable the 2nd Ethernet port to make it work. (Please refer to
www.icpdas.com
3. When the 2nd Ethernet port is enabled, it default supports the Modbus TCP/IP slave protocols. The
first and the 2nd Ethernet port can also support the "udp_ip" and "tcp_clie" to delivery data to PC /
HMI or other devices. (Please refer to the section 19.2 and 19.3 of the ISaGRAF User's manual -
ser_manual_i_8xx7.pdf" and "user_manual_i_8xx7_appendix.pdf")
Ap-22
> Support > FAQ > ISaGRAF Soft-Logic PAC
ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
> FAQ-093)