Table of Contents
Advertisement
A.3 Setting The IP Address For The ViewPAC
Please run "Start" – "Setting" – "Control Panel" on the ViewPAC, then double click on "Network and
Dial-up Connections". Then click on "LAN1" . Set your ViewPAC's IP address and its Subnet Mask. (Please
always set as Fixed IP for ISaGRAF application, No DHCP)
Note:
nd
Please refer to the
Appendix D
for enabling the 2
Ethernet port of VP-2xW7/2xW6/4137/4136.
Please run "Start" – "Programs" – "ViewPAC Utility", click on "Save and Reboot" to store the setting.
ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
Ap-4
Advertisement
Table of Contents
