Table of Contents
Advertisement
Appendix B
Note:
If you have purchased ISaGRAF WinCE ViewPAC, the ISaGRAF Driver is already installed with a license
when shipping out. You don't need to install it. However if you want to upgrade to newer version, you
may upgrade it by yourself.
The ISaGRAF WinCE ViewPAC 's ISaGRAF driver can be obtained in the ISaGRAF WinCE ViewPAC CD-ROM:
\napdos\isagraf\vp-25w7-23w7\driver\<version Number>\
For example, version 1.01 is located at
\napdos\isagraf\vp-25w7-23w7\driver\1.01\
Or download it from
HMI
>
ISaGRAF
>
ISaGRAF Download List > Driver
1. If your ViewPAC is VP-2xW7/4xx7, please stop "ViewPAC-2xW7/4xx7 ISaGRAF Driver" first. (Click on
"End Driver" to stop it.) However if it is VP-2xW1/4xx1 (ViewPAC without ISaGRAF license), please go
to step 2.
2. Set up ViewPAC 's IP, Mask, FTP directory & Auto-execute
A. Please create a folder "isagraf" inside "\System_Disk" folder in your ViewPAC controller. Then it
will be \System_Disk\isagraf\
B. Please run "Start" – "Setting" – "Control Panel" on the ViewPAC, then double click on "Network
and Dial-up Connections". Then click on "LAN1". Set your ViewPAC 's IP address & its Subnet Mask.
(Please always set as Fixed IP for ISaGRAF application, No DHCP)
Upgrade ISaGRAF Driver to Newer Version
www.icpdas.com
>
ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
Product >
Solutions
>
Soft PLC, ISaGRAF & Soft-GRAF
Ap-13
Advertisement
Table of Contents
