Table of Contents
Advertisement
Auto-check system
Introduction
The auto-check system checks important components and vehicle systems.
These background checks are run constantly, as long as the ignition is
switched on.
A message is displayed in the instrument panel if a fault should occur or if any
maintenance or repairs are urgently required. This is accompanied by an
audible warning signal. Depending on the priority of the fault, a red or yellow
warning symbol lights up in the display.
The red symbols indicate a danger, whereas the yellow ones represent a
warning. Additional messages to assist the driver may be shown with the red
or yellow symbols.
Safety First
Operating instructions
Driver messages
Additional messages to assist the driver are displayed
together with the warning symbols in the instrument panel.
Driver messages and red symbols
If a red warning symbol appears in the display, you can press the
⇒ fig. 52
button
to call up an additional driver message.
For example: in the event of an oil pressure malfunction, the oil pressure
symbol
will appear in the display. If you now press the
following message will appear in the display:
Switch off engine, check oil level
The message will disappear from the display after about 5 seconds. If
required, the message can be called up again by briefly pressing the
button.
Practical tips
Cockpit
Fig. 52 Instrument panel:
CHECK button
CHECK
button, the
CHECK
CHECK
Technical Data
75
Advertisement
Table of Contents
