Table of Contents
Advertisement
Driving time warning
After 2 hours of continuous driving, the display automatically switches over
to the driving time display of 2:00. At the same time the driving time display
starts flashing. This is to remind the driver to take a break.
The driving time warning can be switched off by briefly pressing the function
selector switch or the
Reset
If you continue driving or take a break for less than 10 minutes, the driving
time warning will switch on once again when the total driving time is 4:00
hours, 6:00 hours, etc. However, if you take a break for more than 10 minutes,
the driving time warning clock will be erased.
Distance covered
This display shows the distance you have covered since the memory was last
cancelled. The longest possible distance which can be recorded is
9999.9 km.
Note
•
The displays for fuel consumption (average and instantaneous), fuel
range and speed are shown in metric units.
•
The information in the memory is lost if the battery is disconnected.
Safety First
⇒ fig.
button
59.
Operating instructions
Operating
The on-board computer is controlled by means of two
switches on the windscreen wiper lever.
Enabling the on-board computer
A
– Press the reset button
repeatedly until the on-board
B
computer (memory 1 or 2)
Selecting the function
– Press the top or bottom of the function selector switch
⇒ fig.
59. This displays the functions of the on-board computer
in sequence.
Resetting to zero
– Press and hold the Reset button
The following values can be reset to zero using the Reset button:
Practical tips
Cockpit
Fig. 59 Windscreen wiper
lever: On-board computer
controls
⇒ page 84, fig. 58
is displayed.
A
A
A
for at least two seconds.
B
Technical Data
85
Advertisement
Table of Contents
