Table of Contents
Advertisement
Safety check
– Check that the green marking
knob is inside the black zone marked on the ball joint.
– Check that the knob is directly against the ball joint, so that there
is no gap between the knob and the ball joint -arrow-.
– Check that the ball joint is locked and the key is removed so that
the knob cannot be pulled out ⇒
– Check that the ball joint fits tightly in the mounting fixture (try
moving it about to check).
Towing socket
– To plug in the electrical connection for the trailer, pull down the
socket below the bumper
If the safety check is not satisfactory, the ball joint must be fitted again prop-
erly.
WARNING
To avoid accidents, the ball joint must meet all the safety requirements
listed in the safety check. The towing bracket must not be used if any one
of these requirements is not met. If this is the case, you should contact a
specialist garage.
Safety First
A
⇒ page 192, fig. 154
on the
A
.
⇒ page 192, fig.
155.
Operating instructions
Removing the ball joint
A
– Insert the key in the lock
1
– Unlock the ball joint by turning the key to the red marking.
Practical tips
Trailer towing
Fig. 156 Removable
towing bracket: Removing
the ball joint
Fig. 157 Rear bumper:
fitting the cover piece
⇒ fig. 156
on the knob.
Technical Data
193
Advertisement
Table of Contents
