Table of Contents
Advertisement
190
Trailer towing
Fitting the ball joint (step 1)
– Remove the cover piece
A
below the bumper as far as it will go. The cover piece is held
1
automatically in the open position.
– Make sure the mounting fixture is clean. If not, clean it ⇒
Cont ⇒ page 190, "Fitting the ball joint (step 2)".
WARNING
It is important to keep the mounting fixture clean. Otherwise the ball joint
may fail to engage safely and securely. This could lead to an accident.
Fig. 149 Rear bumper:
Open the cover piece
A
⇒ fig. 149
on the mounting fixture
2
Fitting the ball joint (step 2)
.
Fig. 150 Removable
towing bracket: Ball joint
Fig. 151 Removable
towing bracket: Ball joint
Advertisement
Table of Contents
