Table of Contents
Advertisement
254
If and when
Changing the dipped beam headlight bulb
The procedure for changing the bulbs on the front
passenger's side is the same as on the driver's side.
– Switch off the ignition and the lights.
– Raise the bonnet.
– Move the brace
remove the rigid cover, separating the brace side and then
removing the two tabs from the other end of the cover.
– Pull the connector
– Unclip the retainer spring
right.
– Remove the bulb and fit the new one in the headlight casing with
the tab upwards, starting to position it from below.
– Clip on the spring, raising it and pressing it slightly while turning
it anti-clockwise. To ensure correct lighting, the filament must be
Fig. 193 Dipped head-
vertical. When changing the bulb, you can check the position of
lights
the bulb through the headlight glass.
– Connect the connector to the bulb.
– Fit the cover, first inserting the side tabs and then closing the
cover and the brace. Make sure that the gasket sits well on the
casing cover during the operation.
– Check whether the new bulb is working.
– Have the headlight settings checked as soon as possible.
Fig. 194 Dipped head-
lights
⇒ fig. 193
A
in the direction of the arrow and
1
⇒ fig. 194
A
from the bulb.
2
⇒ fig. 194
A
pressing inwards to the
3
Advertisement
Table of Contents
