Seat EXEO 2009 Owner's Manual page 70

Hide thumbs Also See for EXEO 2009:
Table of Contents

Advertisement

68
Cockpit
Entire brake system fault
If the ABS warning lamp
⇒ page 70 (with the handbrake released), this indicates not only a fault
in the ABS function, but probably also a malfunction in the main brake system
as well ⇒
.
will light up in the instrument panel if a fault occurs in the
The symbol
brake system. Please refer to ⇒ page 77.
Electronic differential lock (EDL) fault
The EDL works in conjunction with the ABS. The ABS indicator lamp will light
up
to indicate an EDL fault. Please take the vehicle to a specialist garage
as soon as possible. For further information on the EDL ⇒ page 177.
WARNING
Before opening the bonnet and checking the brake fluid level, observe
the warning information in ⇒ page 213, "Work in the engine compart-
ment".
If the brake warning lamp
warning lamp
, stop the vehicle immediately and check the brake fluid
level in the reservoir. If the fluid level has dropped below the "MIN" mark
you must not drive on otherwise there may be an increased accident risk.
Obtain technical assistance.
If the brake fluid level is correct, the fault in the brake system may have
been caused by a fault in the ABS control function. As a result, the rear
wheels can lock relatively easily when braking. Under certain circum-
stances, the rear of the vehicle could suddenly sway from side to side, with
the subsequent danger of skidding. Drive carefully to the nearest specialist
garage and have the fault rectified.
lights up together with the brake warning lamp
should light up together with the ABS
Seat belt warning lamp*
The warning lamp acts as a reminder to the driver to fasten
the seat belt.
After switching on the ignition, the warning lamp
driver and front passenger (if applicable) have fastened their seat belts.
When the vehicle has reached a certain speed, you will also hear a warning
signal and the warning light will flash.
For further information on the seat belts, see ⇒ page 22.
Indicators and hazard warning lights
Depending on which turn signal is operated, either the left
cator lamp flashes. Both indicator lamps will flash when the hazard warning
lights are switched on.
If one turn signal fails, the indicator lamp will start flashing twice as fast as
normal.
This does not apply when towing a trailer. Where a turn signal lamp does not
work, either on the trailer or on the towing vehicle, the indicator lamp will not
flash. For further information on the indicators, see ⇒ page 119.
Electronic stabilisation programme
This warning lamp monitors the electronic stabilisation
program (ESP).
The warning lamp
has the following functions:
will remain lit until the
 
or right
indi-

Advertisement

Table of Contents
loading

Table of Contents