Table of Contents
Advertisement
108
Unlocking and locking
Opening the windows using the ignition key
– unlock the driver's door with the key and hold the key in the
unlock position until all the windows are open.
Closing the windows using the remote control
– Press and hold the lock button
⇒
.
Closing the windows using the ignition key
– Lock the driver's door with the key and hold the key in the lock
position until all the windows are closed ⇒
The windows will stop moving when you release the remote control button or
turn the key back to its initial position in the door lock.
WARNING
•
Be careful when closing the windows to ensure nobody is hurt.
•
For safety reasons, you should only use the remote control open and
close functions within about 2 metres of the vehicle. To avoid injuries,
always keep an eye on the windows when pressing the button to close
them. The windows stop moving as soon as the button is released.
Possible malfunctions
Automatic open and close function not working
The automatic open and close function will not work if the battery has been
temporarily disconnected. The function can be restored as follows:
•
Close the window as far as it will go by lifting and holding the window
switch.
until all windows are closed
.
•
Release the switch and then lift it again for one second. This will re-enable
the automatic function.
Sun roof / deflector*
Description
The sliding/tilting sun roof is operated using the rotary control
fig.
80. The rotary control for sliding the roof open can be adjusted to several
different settings (with click stops). This control only works when the ignition
is switched on. The rotary control must be in the
the roof up at the rear.
The sun roof will work for about ten minutes after the ignition has been
switched off. However, it is immediately disabled when one of the front doors
is opened.
⇒ page 109,
A
position if you want to tilt
0
Advertisement
Table of Contents
