Seat EXEO 2009 Owner's Manual page 81

Hide thumbs Also See for EXEO 2009:
Table of Contents

Advertisement

Brake pad worn
Speed warning 1
Dynamic headlight range control*
faulty
Self-directing headlights* faulty
Washer fluid level low*
Speed warning 2*
Battery voltage too high or too low* ⇒ page 80
Bulb monitor*
Tyre pressure monitoring system*
Loss of pressure
TPMS
Tyre pressure monitoring system*
System not available
Yellow symbols are used to indicate a Priority 2 fault (warning).
Yellow symbols are accompanied by one warning chime. The function indi-
cated should be checked as soon as possible. If several Priority 2 faults are
detected at the same time, the symbols are displayed one after the other for
about 2 seconds at a time.
Safety First
⇒ page 80
⇒ page 80
⇒ page 80
⇒ page 80
⇒ page 80
⇒ page 80
⇒ page 81
⇒ page 88
⇒ page 66
Operating instructions
Fuel level low
When this symbol
comes on for the first time, there are about 8 to 10 litres
of fuel left in the tank. You should fill up as soon as possible ⇒ page 208.
Diesel particulate filter obstructed
If the symbol
lights up, you may be able to contribute towards automatic
filter cleaning by driving in the right manner. You should drive at a speed of
at least 60 km/h for about 15 minutes in 4th or 5th gear, at an engine speed
of around 2000 rpm. The increase in temperature will burn off any soot in the
filter. When cleaning is successful, the symbol switches off.
If the light on symbol
does not go off, take the vehicle to a specialist
garage to repair the fault.
For further information on the diesel particulate filter, see ⇒ page 183.
WARNING
It is essential that you adjust your speed to suit the weather, road, terrain
and traffic conditions. The recommended driving speed must never lead to
the driver disregarding the traffic regulations.
Light sensor/ rain sensor faulty
Automatic headlights / automatic wipers faulty
If the
symbol appears, this means that the light sensor / rain sensor is not
working. For safety reasons, the dipped beam headlights will then be
switched on permanently when the light switch is set to the AUTO position.
However, you can still switch the lights on and off in the normal way with the
Practical tips
Cockpit
Technical Data
79

Advertisement

Table of Contents
loading

Table of Contents