Seat EXEO 2009 Owner's Manual page 105

Hide thumbs Also See for EXEO 2009:
Table of Contents

Advertisement

Locking the vehicle
A
– Press button
for about 1 second.
B
Opening the tailgate
A
– Press button
and hold for at least one second.
C
The indicators will flash twice as confirmation when you unlock the car. The
vehicle will be locked again automatically if you do not open one of the doors
or the tailgate within 60 seconds after unlocking the car with button
function prevents the vehicle from remaining unlocked if the unlocking
button is pressed by mistake.
On vehicles with the security central locking* feature, you can unlock just the
driver's door and the tank flap by pressing button
vehicle by pressing the button twice.
The indicators flash once when the vehicle is locked to confirm that the doors
and tailgate are properly locked.
Moreover, apart from unlocking the vehicle, the seat* and mirror* memory
programmed in the key is activated. The driver's seat and exterior mirrors will
be automatically adjusted to the positions stored in the memory.
The interior lights will automatically light up when the vehicle is unlocked and
go out when the vehicle is locked, provided that the switch is in the courtesy
light position.
WARNING
Do not leave anyone (especially children) in the car if it is locked from the
outside and the anti-theft security system is enabled, as the doors and
windows cannot then be opened from the inside. Locked doors could delay
assistance in an emergency, potentially putting lives at risk.
Safety First
A
once, or the whole
A
Operating instructions
Note
The remote control should only be used when the doors and the tailgate
are closed.
The remote control should not be used when the vehicle is out of sight.
The anti-theft alarm* can be accidentally triggered and the vehicle locked
if you press the locking button
before inserting the key in the ignition. If this should happen by mistake,
press the unlock button
A
. This
A
Re-synchronising
Should the remote control fail to lock or unlock the vehicle,
the system must be re-synchronised.
– If the vehicle is locked, use the key to unlock the driver's door.
– Press the unlock button
– Insert the key into the ignition and switch on the ignition.
– Switch off the ignition and remove the key.
– Press the unlock
Practical tips
Unlocking and locking
on the remote control inside the vehicle
.
on the remote control.
or the lock button
.
Technical Data
103

Advertisement

Table of Contents
loading

Table of Contents