Table of Contents
Advertisement
1.7.4 Connecting PoE Converter and IR LED Ring for GV-FE3403 /
5303
To install a PoE converter, follow the steps below.
Note: Instead of installing the PoE converter, you can connect the camera to a PoE switch
and the IR LED ring with a power adapter (optional accessory).
1.
Connect the PoE converter to a PoE switch with a standard network cable. Use the
RJ-45 connector on the left.
Note:
1.
Due to limited space inside the PoE converter, use a standard network cable without
the rubber boot.
2.
The camera will not work if you connect the wrong devices to the two RJ-45
connectors on the PoE converter.
2.
Connect PoE Converter and the camera with the supplied network cable. Use the RJ-45
connector on the right.
Figure 1-39
Introduction
1
37
Advertisement
Table of Contents
