Table of Contents
Advertisement
4.1.5 Tampering Alarm
The Tampering Alarm is used to detect when the camera is being physically tampered with.
An alarm can be generated when the camera is moved, covered up, or out of focus. The
alarm types include triggering the output device, e-mail alert and notifying the connected
GV-Center V2, GV-Vital Sign Monitor, GV-System, and GV-VMS.
Note: Tampering Alarm with triggered output device is only supported by GV-FE2301 /
4301 and GV-FER12203.
To establish the tampering alarm, set up at least one of these alarm types properly.
•
To trigger the output device when a tampering event occurs, enable the output setting
and select Tampering Alarm. See Output Setting in 4.2.2 Output Settings.
•
To trigger the e-mail alert when a tampering event occurs, enable the e-mail setting and
select Tampering Alarm. See 4.3.1 E-Mail.
•
To notify GV-Center V2, GV-Vital Sign Monitor, GV-System, and GV-VMS when a
tampering event occurs, enable the connection to these systems. See 8.1 Center V2, 8.2
Vital Sign Monitor and 7.1 Setting up GV-IP Cameras respectively.
92
Figure 4-8
Advertisement
Table of Contents
