Table of Contents
Advertisement
Chapter 2 Getting Started
This section provides basic information to get the camera working on the network.
2.1 Installing on a Network
These instructions describe the basic connections to install the camera on the network.
1.
Using a standard network cable, connect the camera to your network.
2.
Connect power using one of the methods:
•
Using the supplied power adapter, connect to power. For details, see 1.7
Connecting the Data Cable.
•
Use the Power over Ethernet (PoE) function. The power will be provided over the
network cable.
3.
You can now access the Web interface of the camera.
•
If the camera is installed in a LAN without the DHCP server, the default IP address
192.168.0.10 will be applied. You also can assign a static IP address. See 2.1.2
Assigning an IP Address.
•
If the camera is installed in a LAN with the DHCP server, use GV-IP Device Utility to
look up the camera's dynamic IP address. See 2.1.1 Checking the Dynamic IP
Address.
Note: See "Power over Ethernet" in Specifications later in this manual before purchasing a
PoE adapter.
Getting Started
2
43
Advertisement
Table of Contents
