Table of Contents
Advertisement
The storage device status is indicated in the status column:
Status
Formatting
Unknown
OK
Try Mount
Error File System
Read Only
Repairing
Note:
1. If Enable Recycle is selected, the available space of the storage device must be
higher than the space you specified at the Stop recording or recycle disk when free
space of disk is smaller than x option. Otherwise no video will be recoded.
2. The recording data may be lost if you remove the storage device during recording.
3. If you do not remove the storage device properly, the data cannot be read in another
computer. In this case, re-plug the storage device back to the camera. The system will
repair the data automatically. When the system is repairing the data, the Remove field
will display "Repairing".
4. To upgrade the firmware from versions earlier than V2.07 to the latest version, be sure
to back up the recordings on the camera's memory card first before the upgrade, and
re-format the memory card after the upgrade. If you have not done so, this warning
message appears when you view the Monitoring or Storage Settings' Web interface:
Description
The storage device is being formatted.
The camera cannot recognize the format of the storage device or
the device cannot be found.
Storage formatting is successful.
The camera is attempting to connect to the storage device.
There is a recording error in the storage device. All the recording
data is inaccessible under this status.
The storage device cannot be written to due to abnormal power
disruption.
The system is attempting to repair the recording data.
Figure 4-36
Administrator Mode
4
135
Advertisement
Table of Contents
