GeoVision GV-FE2301 User Manual page 40

5. Open the camera cover by unscrewing the indicated screws.
Figure 1-17
6. Connect the Ethernet cable.
a. Unplug the LAN / PoE connector and prepare an Ethernet cable with only one RJ-
45 connector.
Figure 1-18
b. Thread the Ethernet cable through the opening into the camera and through the
plug and cap as shown below. Use the supplied ruler to make sure the length of the
cable from the opening to the end of the cable is about 10 cm.
c. Insert the plug into the opening and tighten the cap.
26
Figure 1-19