Table of Contents
Advertisement
To enable connection to Backup Center:
1. Activate Link: Enable the connection to the Backup Center.
2. Host Name or IP Address: Type the host name or IP address of the Backup Center.
3. Port Number: Match the communication port on the Backup Center. Or keep the default
value 30000.
4. User Name: Type a valid user name to log into the Backup Center.
5. Password: Type a valid password to log into the Backup Center.
6. Backup Video: Select the streams to back up their recordings to the Backup Center.
7. Compact Video: Select the streams to only back up their Key Frames to the Backup
Center, instead of full recordings. This option is useful to save the backup time.
8. Resend all files: Select this option to send all the recorded files that have been received
by the Backup Center again.
9. Enable Schedule Mode: Enable the Backup Center connection on the schedule you set
in the Select Schedule Time section. Refer to 4.5 Recording Schedule for the same
settings.
10. Click Apply. The Connection Status should display "Connected" and connected time.
If the Backup Center has a failover server to provide uninterrupted backup services in case
the primary Backup Center fails, you can enable the automatic failover support.
1. Automatic Failover Support: Enable automatic connection to a secondary failover
server once the connection between camera and the primary Backup Center is
interrupted.
2. Host Name or IP Address: Type the host name or IP address of the failover center.
3. Port Number: Match the communication port on the failover server. Or keep the default
value 30000.
4. User Name: Type a valid user name to log into the failover server.
5. Password: Type a valid password to log into the failover server.
6. Click Apply.
Administrator Mode
4
107
Advertisement
Table of Contents
