GeoVision GV-FE2301 User Manual page 119

To enable the Vital Sign Monitor connection:
1. Activate Link: Enable the monitoring through Vital Sign Monitor.
2. Host Name or IP Address: Type the host name or IP address of Vital Sign Monitor.
3. Port Number: Match the port to Port 2 on Vital Sign Monitor. Or keep the default
value 5609. For details, see 8.2 Vital Sign Monitor.
4. User Name: Type a valid user name to log into Vital Sign Monitor.
5. Password: Type a valid password to log into Vital Sign Monitor.
6. Click Apply. The Connection Status should display "Connected" and connected time.
7. To establish the connection to the second Vital Sign Monitor, click the Connection 2
tab and repeat the above steps for setup.
These options you can also find on this Vital Sign Monitor setting page:
Cease motion detection messages from: Stops notifying Vital Sign Monitor of
motion-triggered events.
Cease input trigger messages from: Stops notifying Vital Sign Monitor of input-
triggered events.
Enable schedule mode: Starts the monitoring through Vital Sign Monitor based on
the schedule you set in the Select Schedule Time section. Refer to 4.5 Recording
Schedule for the same settings.
For related settings to activate the monitoring through Vital Sign Monitor, see 4.1.2 Motion
Detection, 4.2.1 Input Settings, and 8.2 Vital Sign Monitor.
Administrator Mode
4
105