Table of Contents
Advertisement
Tip: Instead of searching for available NAS servers, you can also type the storage path
directly.
1. Type the Server URL/ IP Address in this format: \\NAS IP Address\Storage Folder.
For example, \\192.168.0.1\IP_Camera. This GV-IP Camera will be recorded to a
default shared folder named "IP_Camera" in the GV-NAS System.
2. Type the username and password. For GV-NAS System, you can type any of default
usernames Can01 to Cam16, and password is 12345678.
For details on GV-NAS System, refer to GV-NAS System Quick Start Guide.
[Disk Information]
This section shows the details of the attached storage devices. Use the Format or Remove
button to format or unload a storage device. For detail steps, see Partition Information below.
[Partition Information]
This section shows the partition details of the attached storage devices.
To add a memory card:
1. Insert the memory card to the camera.
2. Click the Format button.
3. After the format is complete, the partition information will display. The maximum space
for one partition is 200 GB.
To remove a memory card:
1. Click the Remove button.
2. When you are prompted to confirm the action, click Yes. The page will be refreshed
and the partition information will be cleaned.
3. Remove the memory card from the camera.
134
Advertisement
Table of Contents
