Table of Contents
Advertisement
About this task
To remove the air baffle, complete the following steps.
Procedure
1. Remove the cover (see "Removing the cover" on page 33).
2. Place your fingers under the front and back of the top of the air baffle; then, lift
Figure 23. Air baffle removal
Installing the 2.5-inch simple-swap hard disk drive backplate assembly
Use this information to install the 2.5-inch simple-swap hard disk drive backplate
assembly.
Before you begin
Read the safety information in "Safety" on page v and "Installation guidelines" on
page 31.
If you are installing an optional device in the server, you need to slide the server
out from the rack enclosure, turn off the server and peripheral devices, and
disconnect the power cords and all external cables.
About this task
There are three types of 2.5-inch simple-swap hard disk drive backplate assemblies:
the air baffle out of the server.
Attention: For proper cooling and airflow, replace the air baffle before you
turn on the server. Operating the server with the air baffle removed might
damage server components.
Chapter 2. Installing optional devices
35
Advertisement
Table of Contents
Troubleshooting
