Lenovo 5458 Installation And Service Manual page 52

Figure 24. 2.5-inch simple-swap hard disk drive backplate assemblies
To install the 2.5-inch simple-swap hard disk drive backplate assembly, complete
the following steps:
Procedure
1. Remove the cover (see "Removing the cover" on page 33).
2. Remove the PCI riser-card assembly if applicable (see "Removing the PCI
3. Align the backplate assembly with the backplate assembly alignment slots in
4. Lower the backplate assembly into the slot in the chassis until the front tab
Figure 25. 2.5-inch simple-swap hard disk drive backplate assembly installation
36
System x3250 M5 Type 5458: Installation and Service Guide
riser-card assembly" on page 169).
the chassis.
clicks into the latches on the chassis.