Appendix B. Uefi (Post) Error Codes - Lenovo 5458 Installation And Service Manual

Appendix B. UEFI (POST) error codes

This section details the UEFI (POST) error codes.
UEFI (POST) diagnostic error codes can be generated when the server starts up or
while the server is running. UEFI (POST) codes are logged in the IMM2 event log
in the server.
For each event code, the following fields are displayed:
Event identifier
Event description
Explanation
Severity
User response
The following is the list of the UEFI (POST) error codes and suggested actions to
correct the detected problems.
I.2018002 [I.2018002] The device found at Bus %
Device % Function % could not be
configured due to resource constraints.
The Vendor ID for the device is % and
the Device ID is %.
Explanation: OUT_OF_RESOURCES (PCI Option
ROM)
Severity: Info
© Copyright Lenovo 2015, 2015
An identifier that uniquely identifies an event.
The logged message string that appears for an event.
Additional information to explain why the event occurred.
An indication of the level of concern for the condition. The severity is
abbreviated in the event log to the first character. The following severities
can be displayed:
Table 38. Event severity levels
Severity
Informational
Warning
Error
Indicate the actions that you should take to resolve the event.
Perform the steps listed in this section in the order shown until the
problem is solved. After you perform all of the actions that are described
in this field, if you cannot solve the problem, contact IBM support.
Description
An informational message is something that was recorded for
audit purposes, usually a user action or a change of states that is
normal behavior.
A warning is not as severe as an error, but if possible, the
condition should be corrected before it becomes an error. It
might also be a condition that requires additional monitoring or
maintenance.
An error typically indicates a failure or critical condition that
impairs service or an expected function.
User response: Complete the following steps:
If this PCIe device and/or any attached cables
1.
were recently installed, moved, serviced or
upgraded, reseat adapter and any attached cables.
Check IBM Support website for any applicable
2.
service bulletin or UEFI or adapter firmware update
that applies to this error. NOTE: It may be
necessary to disable unused option ROMs from
397