Table of Contents
Advertisement
Figure 46. 3.5-inch simple-swap hard disk drive installation
b. Gently push the drive into the bay until the drive stops.
4. Reinstall the drive bay filler panel that you removed earlier.
5. If you are installing additional simple-swap hard disk drives, do so now.
What to do next
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 79.
Installing the optional DVD drive
Use this information to install the DVD drive.
Before you begin
Read the safety information in "Safety" on page v and "Installation guidelines" on
page 31.
If you are installing an optional device in the server, you need to slide the server
out from the rack enclosure, turn off the server and peripheral devices, and
disconnect the power cords and all external cables.
About this task
To install the DVD drive, complete the following steps.
Procedure
1. Remove the cover (see "Removing the cover" on page 33).
2. Remove the DVD drive filler panel if it is installed. Locate the blue release tab
on the rear of the DVD drive filler panel; then, while you press the tab, push
the DVD drive filler panel out of the drive bay.
Chapter 2. Installing optional devices
51
Advertisement
Table of Contents
Troubleshooting
