Installing A Usb Embedded Hypervisor Flash Device - Lenovo 5458 Installation And Service Manual

Figure 63. RAID adapter battery or flash power module installation
8. Reinstall the PCI riser-card assembly (see "Replacing the PCI riser-card
What to do next
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 79.

Installing a USB embedded hypervisor flash device

Use this information to install a USB embedded hypervisor flash device.
Before you begin
Read the safety information in "Safety" on page v and "Installation guidelines" on
page 31.
If you are replacing a server component in the server, you need to slide the server
out from the rack enclosure, turn off the server and peripheral devices, and
disconnect the power cords and all external cables.
About this task
To install a hypervisor flash device, complete the following steps.
Note: The positioning of the remote battery or flash power module depends
on the type of the remote batteries or flash power modules that you install.
d. Connect the other end of the cable to the cable connector on the battery or
flash power module.
e. Lower and press down on the retention clip until it snaps in place to hold
the battery or flash power module firmly in place.
f. Install the retainer.
assembly" on page 79).
Chapter 2. Installing optional devices
71