Table of Contents
Advertisement
Figure 54. Adapter installation
7. Install the PCI riser-card assembly (see "Replacing the PCI riser-card assembly"
What to do next
If you have other devices to install, do so now. Otherwise, go to "Completing the
installation" on page 79.
Note: If the server is configured for RAID operation through an optional
ServeRAID adapter, you might have to reconfigure your disk arrays after you
install an adapter. See the ServeRAID documentation on the Lenovo ServerRAID
Support CD for additional information about RAID operation and complete
instructions for using ServeRAID Manager.
Installing an Lenovo ServeRAID SAS/SATA controller
Use this information to install an Lenovo ServeRAID SAS/SATA controller.
Before you begin
For configuration information, see the ServeRAID SAS/SATA controller
documentation at http://www.lenovo.com/support.
Important: To ensure that any of your Lenovo ServeRAID SAS/SATA controllers
function properly on UEFI-based servers, make sure that the ServeRAID
SAS/SATA controller firmware and supporting device drivers are updated to the
latest version.
Read the safety information in "Safety" on page v and "Installation guidelines" on
page 31.
on page 79).
Attention: When you install an adapter, make sure that the adapter is
correctly seated in the PCI riser-card assembly and that the PCI riser-card
assembly is securely seated in the riser-card connector on the system board
before you turn on the server. An incorrectly seated adapter might cause
damage to the system board, the PCI riser-card assembly, or the adapter.
Chapter 2. Installing optional devices
61
Advertisement
Table of Contents
Troubleshooting
