Updating The Server Configuration - Lenovo 5458 Installation And Service Manual

Figure 77. Input and output connectors on the back of the redundant power-supply server
model
Procedure
1. You must turn off the server before you connect or disconnect cables.
2. See the documentation that comes with any external devices for additional
3. Cable identifiers are printed on the cables that come with the server and
What to do next
Refer to the "Internal cable routing and connectors" on page 272 for internal cable
routing information.

Updating the server configuration

Use this information to update the server configuration.
About this task
When you start the server for the first time after you add or remove a device, you
might receive a message that the configuration has changed. The Setup utility
starts automatically so that you can save the new configuration settings.
Some optional devices have device drivers that you must install. For information
about installing device drivers, see the documentation that comes with each device.
If the server has an optional RAID adapter and you have installed or removed a
hard disk drive, see the documentation that comes with the RAID adapter for
information about reconfiguring the disk arrays.
For information about configuring the Ethernet controller, see "Configuring the
Ethernet controller" on page 101.
84
System x3250 M5 Type 5458: Installation and Service Guide
cabling instructions. It might be easier for you to route cables before you
connect the devices to the server.
optional devices. Use these identifiers to connect the cables to the correct
connectors.