Lenovo 5458 Installation And Service Manual page 209

Figure 113. DVD drive cable connection
3. Secure the cable in the server using the cable tie and cable clip.
4. Reinstall the DVD drive bay filler panel that you removed earlier.
5. Reinstall the cover (see "Replacing the cover" on page 81).
What to do next
1. Install the server into the rack enclosure and push the server into the rack until
it clicks into place.
2. Reconnect the power cords and any cables that you removed.
3. Turn on the peripheral devices and the server.
Removing an adapter
Use this information to remove an adapter.
Before you begin
Read the safety information in "Safety" on page v and "Installation guidelines" on
page 31.
If you are replacing a server component in the server, you need to slide the server
out from the rack enclosure, turn off the server and peripheral devices, and
disconnect the power cords and all external cables.
193
Chapter 6. Removing and replacing server components