Lenovo 5458 Installation And Service Manual page 198

Figure 100. 3.5-inch hot-swap hard disk drive removal
3. Grasp the handle and pull the hot-swap hard disk drive out of the drive bay.
4. Reinstall the drive bay filler panel.
What to do next
If you are instructed to return the server component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Replacing a hot-swap hard disk drive
Use this information to replace a hot-swap hard disk drive.
Before you begin
The following notes describe the type of hard disk drives that the server supports
and other information that you must consider when you install a hard disk drive.
For a list of supported hard disk drives, see http://www.ibm.com/systems/info/
x86servers/serverproven/compat/us.
v Locate the documentation that comes with the hard disk drive and follow those
v Make sure that you have all the cables and other equipment that are specified in
v Select the bay in which you want to install the drive.
v Check the instructions that come with the drive to determine whether you have
v You can install up to to eight 2.5-inch or four 3.5-inch hot-swap SAS or SATA
v The electromagnetic interference (EMI) integrity and cooling of the server are
v For a complete list of supported optional devices for the server, see
182
System x3250 M5 Type 5458: Installation and Service Guide
instructions in addition to the instructions in this chapter.
the documentation that comes with the drive.
to set any switches or jumpers on the drive. If you are installing a SAS or SATA
hard disk drive, be sure to set the SAS or SATA ID for that device.
hard disk drives in the server.
protected by having all bays and PCI and PCI Express slots covered or occupied.
When you install a drive, PCI, or PCI Express adapter, save the EMC shield and
filler panel from the bay or PCI or PCI Express adapter slot cover in the event
that you later remove the device.
http://www.ibm.com/systems/info/x86servers/serverproven/compat/us.