Hard Disk Drive Assembly (For Selected Models) - Lenovo ThinkPad L14 Gen 2 User Manual

Removal procedure
Note: A Mylar film might cover the wireless WAN card. To access the wireless WAN card, peel off the film
first.

Hard disk drive assembly (for selected models)

Prerequisite
Before you start, read Generic Safety and Compliance Notices and print the following instructions.
Attention: The internal storage drive is sensitive. Inappropriate handling might cause damage and
permanent loss of data.
When handling the internal storage drive, observe the following guidelines:
• Replace the internal storage drive only for upgrade or repair. The internal storage drive is not designed for
frequent changes or replacement.
• Before replacing the internal storage drive, make a backup copy of all the data that you want to keep.
• Do not touch the contact edge of the internal storage drive. Otherwise, the internal storage drive might get
damaged.
• Do not apply pressure to the internal storage drive.
• Do not make the internal storage drive subject to physical shocks or vibration. Put the internal storage
drive on a soft material, such as cloth, to absorb physical shocks.
For access, do the following:
1. Disable the built-in battery. See "Disable Fast Startup and the built-in battery" on page 37.
2. Turn off the computer and disconnect the computer from ac power and all connected cables.
3. Close the computer display and turn the computer over.
4. Remove the base cover assembly. See "Base cover assembly" on page 38.
.
Chapter 6 CRU replacement
41