Lenovo 5458 Installation And Service Manual page 108

92
System x3250 M5 Type 5458: Installation and Service Guide
Select this choice to enable or disable devices from taking control of the
boot process. The default is Disable.
- Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass
storage devices that are non-UEFI compliant. The default is Enable.
- Infinite Boot Retry
Select this choice to enable or disable UEFI to infinitely retry the legacy
boot order. The default is Disable.
- BBS Boot
Select this choice to enable or disable legacy boot in BBS manner. The
default is Enable.
– System Security
Select this choice to view or configure Trusted Platform Module (TPM)
support.
– Integrated Management Module II (IMM2)
Select this choice to view or change the settings for the Integrated
Management Module II (IMM2).
- Power Restore Policy
Select this choice to set the mode of operation after the power lost.
- Commands on USB Interface
Select this choice to enable or disable the Ethernet over USB interface on
IMM2. The default is Enable.
- Network Configuration
Select this choice to view the system management network interface port,
the IMM2 MAC address, the current IMM2 IP address, and host name;
define the static IMM2 IP address, subnet mask, and gateway address,
specify whether to use the static IP address or have DHCP assign the
IMM2 IP address, save the network changes, and reset the IMM2.
- Reset IMM2 to Defaults
Select this choice to view or reset IMM2 to the default settings.
- Reset IMM2
Select this choice to reset IMM2.
– Recovery
Select this choice to view or change the system recovery parameters.
- POST Attempts
Select this choice to view or change the number of attempts to POST.
v POST Attempts Limit
Select this choice to view or change the Nx boot failure parameters.
- System Recovery
Select this choice to view or change system recovery settings.
v POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
v POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
v Reboot System on NMI
Select this choice to enable or disable restarting the system whenever a
nonmaskable interrupt (NMI) occurs. Enable is the default.