Starting The Backup Server Firmware; The Updatexpress System Pack Installer; Changing The Power Policy Option To The Default Settings After Loading Uefi Defaults - Lenovo 5458 Installation And Service Manual

About this task
The Boot Manager program is a built-in, menu-driven configuration utility
program that you can use to temporarily redefine the first startup device without
changing settings in the Setup utility.
To use the Boot Manager program, complete the following steps:
Procedure
1. Turn off the server.
2. Restart the server.
3. When the prompt <F12> Select Boot Device is displayed, press F12.
4. Use the Up arrow and Down arrow keys to select an item from the menu and
Results
The next time the server starts, it returns to the startup sequence that is set in the
Setup utility.

Starting the backup server firmware

Use this information to start the backup server firmware.
The system board contains a backup copy area for the server firmware. This is a
secondary copy of the server firmware that you update only during the process of
updating the server firmware. If the primary copy of the server firmware becomes
damaged, use this backup copy.
To force the server to start from the backup copy, turn off the server; then, place
the UEFI boot backup jumper in the backup position (pins 2 and 3) to enable the
UEFI recovery mode. See "System-board switches and jumpers" on page 27 for the
location of the UEFI boot backup jumper.
Use the backup copy of the server firmware until the primary copy is restored.
After the primary copy is restored, turn off the server; then, move the UEFI boot
backup jumper back to the primary position (pins 1 and 2).

The UpdateXpress System Pack Installer

The UpdateXpress System Pack Installer detects supported and installed device
drivers and firmware in the server and installs available updates.
For additional information and to download the UpdateXpress System Pack
Installer, go to the ToolsCenter for System x and BladeCenter at
http://publib.boulder.ibm.com/infocenter/toolsctr/v1r0/ and click UpdateXpress
System Pack Installer.
Changing the Power Policy option to the default settings after
loading UEFI defaults
The default settings for the Power Policy option are set by the IMM2.
96
System x3250 M5 Type 5458: Installation and Service Guide
press Enter.