Rear View - Lenovo 5458 Installation And Service Manual

v Hard disk drive activity LED:
v System-locator LED:
v Check log LED:
v System-error LED:
v USB connectors:

Rear view

The following illustrations show the connectors and LEDs on the rear of the server.
The following illustration shows the LEDs and connectors on the rear of the fixed
power-supply model.
Figure 12. Connectors on the rear of the fixed power-supply model
18
System x3250 M5 Type 5458: Installation and Service Guide
Press this button to reset the server and run the power-on self-test (POST). You
might have to use a pen or the end of a straightened paper clip to press the
button.
When this LED is flashing, it indicates that the associated hard disk drive is in
use.
Use this blue LED to visually locate the server among other servers. This LED is
also used as a presence detection button. You can use Systems Director to light
this LED remotely. This LED is controlled by the IMM2.
When this yellow LED is lit, it indicates that a system error has occurred. Check
the event log for additional information. See "Event logs" on page 125 for more
information about event logs.
When this yellow LED is lit, it indicates that a system error has occurred. Check
LEDs on the system board to help isolate the error or identify the failed part.
This LED is controlled by the IMM2.
Connect a USB device, such as a USB mouse, keyboard, or other device to any
of these connectors.