Lenovo 5458 Installation And Service Manual page 261

About this task
To replace the 3.5-inch simple-swap hard disk drive backplate assembly, complete
the following steps:
Procedure
1. Lower the backplate assembly into the alignment slots in the chassis.
2. Align the tabs of the drive backplate assembly with the backplate assembly
slots at the back of the backplate assembly cage.
Figure 160. 3.5-inch simple-swap hard disk drive backplate assembly alignment
3. Insert the drive backplate assembly slots into the tabs of the backplate assembly
cage. Rotate the drive backplate assembly forward and push down the
retention latch on top of the drive cage until the backplate assembly is latched.
Chapter 6. Removing and replacing server components
245