Lenovo 5458 Installation And Service Manual page 184

2. Remove the drives and drive bay filler panels from the drive bays (see
3. Remove the screws from the bezel.
Figure 89. Bezel removal
4. Pull the top of the bezel out slightly; then, rotate it downward until the tabs on
What to do next
If you are instructed to return the server component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Replacing the bezel
Use this information to replace the bezel.
Before you begin
Read the safety information in "Safety" on page v and "Installation guidelines" on
page 31.
If you are replacing a server component in the server, you need to slide the server
out from the rack enclosure, turn off the server and peripheral devices, and
disconnect the power cords and all external cables.
About this task
To replace the bezel, complete the following steps.
Procedure
1. Insert the tabs on the bottom of the bezel into the holes on the chassis.
2. Rotate the bezel upward to the server and reinstall the bezel screws.
168
System x3250 M5 Type 5458: Installation and Service Guide
"Removing a hot-swap hard disk drive" on page 180, or "Removing a
simple-swap hard disk drive" on page 184, or "Removing the optional DVD
drive" on page 187).
the bottom of the bezel disengages from the chassis and set it aside.