Lenovo 5458 Installation And Service Manual page 225

Figure 128. USB embedded hypervisor flash device removal
What to do next
If you are instructed to return the server component or optional device, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Replacing a USB embedded hypervisor flash device
Use this information to replace a USB embedded hypervisor flash device.
Before you begin
Read the safety information in "Safety" on page v and "Installation guidelines" on
page 31.
If you are replacing a server component in the server, you need to slide the server
out from the rack enclosure, turn off the server and peripheral devices, and
disconnect the power cords and all external cables.
About this task
To replace a hypervisor flash device, complete the following steps.
Procedure
1. Align the USB flash device with the connector on the system board and push it
into the connector until it is firmly seated.
2. Slide the lockbar on the flash device connector to the locked position until it is
firmly seated.
Chapter 6. Removing and replacing server components
209