Emerson Rosemount 700XA Reference Manual page 178

Operation and maintenance
June 2022
Table 5-5: F
Board
LOI
For more details, consult the following drawings:
Figure 5-62: Preamplifier board
JP1 on the preamplifier board should not be set. The preamplifier board is located in slot 1
of the card cage.
Figure 5-63: Heater/solenoid driver board
JP1 on the heater/solenoid driver board should not be set. The heater/solenoid driver
board is located in slot 2 of the card cage. If there is an additional heater/solenoid driver
board, it will be located in slot 4, and its JP1 jumper also should not be set.
The Base I/O board, which is located in slot 3 of the card cage, has three jumpers that
affect the performance of the Foundation Fieldbus.
178
Fieldbus jumper settings
OUNDATION
(continued)
Jumper Set?
S4 No
J1 Yes
Reference Manual
2-3-9000-744
Emerson.com/Rosemount