Pos : 166 /100 Sigma/110 BA Z entrifugen Sigma (Proj ekte)/2-16KL_2- 16KH L/070 Störungen und F ehl ers uche/070- 0010-0010 N otentriegel ung 2-16KL_KH L @ 29\mod_1405321449066_68.doc x @ 196777 @ 3 @ 1
7.1.1
Emergency lid release
WARNING
Pos : 167 /010 Univ ers almodul e/
Seitenwechs el @ 0\mod_1202116244312_0.docx @ 105 @ @ 1
50 / 82
In the event of a power failure, it is possible to manually open the centrifuge
lid.
•
Switch off the mains power switch and disconnect the power cord from
the socket.
•
Remove the plug (see figure, item 1) from the opening at the side panel,
e.g. with a screwdriver.
Fig. 28: Position of the opening for the emergency lid release
•
The plug is connected with a string. Pull the string in order to release
the lid.
•
Then, reinsert the stopper into the opening.
Do not unlock or open the lid unless the rotor is at a standstill.
If the lid is opened via the emergency lid release system during a centrifuge
run, the centrifuge will be switched off immediately and decelerate in an
unbraked manner.
Translation of the original operating manual, part no. 0700702