Sound Signal ("Buzzer"); Program Lock ("Proglock") - Sigma 2-16KL Operating Manual

Refrigerated Centrifuge Sigma 2-16KL
6 Using the centrifuge
→ Pos : 145 /100 Sigma/100 BA Z entrifugen Sigma (Standardm odul e)/060 Betrieb_Spi nc ontr ol L+S/Spinc ontrol L (Z ent6) /060- 0030-0020- 0110 Ak ustisc hes Signal @ 27\m od_1405319286360_68.docx @ 192885 @ 4 @ 1

6.3.2.11 Sound signal ("Buzzer")

Pos : 146 /010 Univ ers almodul e/ Leerz eile @ 0\mod_1202116244500_0.docx @ 114 @ @ 1
Pos : 147 /100 Sigma/100 BA Z entrifugen Sigma (Standardm odul e)/060 Betrieb_Spi nc ontr ol L+S/Spinc ontrol L (Z ent6) /060- 0030-0020- 0120 Programms perre @ 27\mod_1405319288819_68.docx @ 192913 @ 4 @ 1

6.3.2.12 Program lock ("ProgLock")

Pos : 148 /010 Univ ers almodul e/ Seitenwechs el @ 0\mod_1202116244312_0.docx @ 105 @ @ 1
44 / 82
This function is used to set an acoustic warning signal that sounds at the
end of the centrifugation run and also in the event of an imbalance or error
message.
In order to activate the sound signal:
•
Select the "Buzzer" symbol with the cursor and confirm the selection.
The symbol and the bar under the symbol start to flash.
•
Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
•
Turning the function knob further will deactivate the function. In this
case, the symbol disappears but the bar continues to flash.
•
Press the function knob in order to activate the desired setting. The bar
remains visible as long as the cursor is placed over the symbol.
Fig. 21: The sound signal "Buzzer" is activated
When the program lock is active, it is impossible to save any new
programs. In this case, the function "save program" is disabled.
In order to activate the program lock:
•
Select the "ProgLock" symbol with the cursor and confirm the selection.
The symbol and the bar under the symbol start to flash.
•
Activate the function by turning the function knob. The symbol remains
displayed in a permanent manner and the bar continues to flash.
•
Turning the function knob further will deactivate the function. In this
case, the symbol disappears but the bar continues to flash.
•
Press the function knob in order to activate the desired setting. The bar
remains visible as long as the cursor is placed over the symbol.
Fig. 22: The program lock "ProgLock" is activated
Translation of the original operating manual, part no. 0700702
Version 08/2012, Rev. 1.24 of 28/04/2022 • sb