Turning The Pump On/Off; Resetting Reservoir Volume - SIMS Deltec CADD-Legacy PLUS Operator's Manual

Ambulatory infusion pump
Table of Contents

Advertisement

Section 3: Operating the Pump
Three sets of dashes will appear one-by-one on the pump's
display, each accompanied by a single beep.
2. Release
pump beeps.

Turning the Pump On/Off

When the pump is stopped, you may put the pump into a low power
state by turning it off. The pump may be turned off when it is discon-
nected from the patient and it is going to be stored for short periods of
time.
CAUTION: Do not store the pump for prolonged periods of time
with the batteries installed. Battery leakage could damage the pump.
To turn the pump off
• Press and hold
Three sets of dots will appear one-by-one on the pump's
display, each accompanied by a single beep.
To turn the pump on
• Press and hold
matically review all screens.

Resetting Reservoir Volume

To reset the Reservoir Volume to the value programmed in LL0, the
pump may be in any lock level.
1. Stop the pump.
2. Press
¤
3. Press
44
after the third set of dashes appears and the
Å
.
Å
. The pump will power up and auto-
to display the Reservoir Volume screen.
to reset the volume to the programmed value.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CADD-Legacy PLUS and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

6500

Table of Contents