Changing To Lock Level 0 (Ll0) - SIMS Deltec CADD-Legacy PLUS Operator's Manual

Changing to Lock Level 0 (LL0)

Before programming the pump, make sure the pump is set to LL0.
LL0 allows the clinician to access all programming and operating
functions.
1. Make sure the pump is stopped. Press
lock level will appear. (If the lock level is already LL0, press
„
to exit.)
´
2. Press
Œ
3. Press
´
4. Press
WARNING: Do not disclose to the patient the pump's
security codes or any other information that would allow
the patient complete access to all programming and operat-
ing functions. Improper programming could result in death
or serious injury to the patient.
Œ
5. Press
Section 2: Pump Setup and Programming
Î
or until "LL0" appears.
¤
again or . "Code 0" will appear.
Î
or until the Lock Level Code
¤
or to set the new lock level.
Œ
. The current
****
appears.
17