Programming In The Intermittent Delivery Mode - SIMS Deltec CADD-Legacy PLUS Operator's Manual

Section 2: Pump Setup and Programming

Programming in the Intermittent Delivery Mode

Be sure the pump is in the intermittent delivery mode versus the
continuous delivery mode. To program the pump, enter the pre-
scribed values.
1. Begin at the main screen.
• Make sure the pump is in LL0.
• Make sure STOPPED appears on the main screen.
„
• Press
2. Enter the Reservoir Volume.
´
• Press
tainer. (If you do not wish to use the Reservoir Volume
feature, scroll down to "Not In Use" located before 1.)
¤
• Press
„
• Press
3. Enter the Dose Volume.
´
• Press
¤
• Press
„
• Press
NOTE: The maximum rate of the pump is 125 ml/hr. The
pump will only allow a dose duration that will not cause a
rate greater than 125 ml/hr for the programmed volume.
4. Enter the Dose Duration.
´
• Press
¤
• Press
28
to begin.
Î
or to select the volume of a filled fluid con-
.
.
Î
or to select the desired volume.
.
.
Î
or to select the desired duration.
.