SIMS Deltec CADD-Legacy PLUS Operator's Manual page 23

• Use two new, AA alkaline batteries to power the pump. You
may use any alkaline batteries, including DURACELL
Alkaline and EVEREADY
example.
4. Place the battery door over the battery compartment and
slide the door closed.
5. Ensure that the door is latched by trying to remove the door
without pressing the arrow button.
NOTE: The power-up sequence will start, the pump will go
through an electronic self-test, and the pump will beep six
times at the end of the power-up sequence. All of the display
indicators, the software revision level, and each parameter
will appear briefly.
Section 2: Pump Setup and Programming
® ENERGIZER
®
® Alkaline, for
13