Programming The Pump: General Instructions - SIMS Deltec CADD-Legacy PLUS Operator's Manual

Section 2: Pump Setup and Programming

Programming the Pump: General Instructions

The procedure for changing a programmed setting is similar for most
programming screens.
• Make sure the pump is stopped and in Lock Level 0.
• To begin programming, start at the main screen and press
„
.
• To change a setting, press
setting appears. (Press and hold these keys to change values
with increasing speed.)
¤
• Press
screen will revert to the previous setting.
• If any key other than
will appear. Press
grammed, scroll to the desired value, and press
„
• Press
• To leave a setting unchanged, press
screen.
18
´
within 25 seconds to confirm a change or the
¤
is pressed, "Value not saved"
„
to return to the screen being pro-
to advance to the next screen.
Î
or until the desired
¤
„
to go to the next
.