Cleaning Of The Nozzle Parts; Starting Up The Vm 5020Wa Control Unit - WAGNER AquaCoat 5010 GA 5000EAW Operating Manual

VERSION 03/2018

7.4.5 CLEANING OF THE NOZZLE PARTS

The nozzle parts (2, 3, 4, 5, 6, 8 and 9) may only be immersed into a cleaning solvent
recommended by the lacquer manufacturer and must be removed again immediately.
They may only remain in a cleaning solvent for a short time.
Clean these parts with a brush and dry them with a cloth or a blow gun.

7.4.6 STARTING UP THE VM 5020WA CONTROL UNIT

1. Turn switch to position 1.
2. All LEDs on the control unit illuminate for approximately
1 second.
3. The hardware version and the software version are shown
on the display alternately in succession.
Hardware version
4. After a few seconds, the control unit is ready for operation.
Note:
Each starting sequence is concluded by allocating the
saved set data in recipe "R1".
ORDER NUMBER DOC 2369735
Software version
80 100
60 80
R1
40 60
20 40
R2
10 20
kV µA
R3
80 100
60 80
R1
40 60
20 40
R2
10 20
kV µA
R3
POWER POWER
0 1
AquaCoat
B_03372
POWER POWER
0 1
AquaCoat
B_03374
63