WAGNER AquaCoat 5010 GA 5000EAW Operating Manual page 93

VERSION 03/2018
1
X = 130 ±0.1 mm
X = 5.12 ±0.004 inch
B_06042
Valve rod unit:
Set length adjusting measure X with collet
chuck (6) and lock with a hexagon nut (2).
Wear gloves!
The outside thread of the packing (3) must be free of lacquer.
Grease, push and screw valve rod unit (4) and packing (3) together.
Grease clamping screw (1) and mount using assembly tool (5).
0.8 Nm + 0.1 Nm;
0.6 + 0.07 lbft
B_05800
ORDER NUMBER DOC 2369735
2Nm; 1.48 lbft
SW7
6
2
3
SW5
4
SW7
0.4 - 0.5 Nm
0.3 - 0.37 lb ft
SW7
2
Coat the hollow section with a brush.
Note: avoid the pin and hexagon.
2
Only as required (if the rod seal was
removed): Press in rod seal (10).
In the process, press only on the lowest
area of the rod seal.
2
10
2
5
1
0.5 Nm
0.37 lb ft
3
4
2
2
B_05786
2
(sparingly)
93