WAGNER AquaCoat 5010 GA 5000EAW Operating Manual page 83

VERSION 03/2018
Disassembling the product hose (5)
From cabinet:
1. Loosen product hose (5) via union nut (6) in cabinet.
2. Loosen knurled nut (4) outside on the cabinet and carefully pull the product hose out
of the cabinet.
From spray gun:
1. Dismount gun covers in accordance with Chapter 8.2.5.
2. Loosen hose from hose holder (7).
3. Slacken product hose (5) at the product connection of the spray gun (1). Use a wrench
when doing this.
Product hoses
Four preassembled product hoses are available in different lengths:
Order No. Designation
2368087 Product hose, complete GA EAW, 7.5 m; 24.6 ft
2368088 Product hose, complete GA EAW, 10 m; 32.81 ft
2368089 Product hose, complete GA EAW, 15 m; 49.2 ft
2368090 Product hose, complete GA EAW, 20 m; 65.6 ft
Assembly
To spray gun:
1. Guide product hose (5) through bushing of lid (8).
2. Clean thread and stripped part of product hose (5). Grease thread with Vaseline (16).
3. Screw product hose (5) to the spray gun product connection (1). Counterhold with a
wrench when tightening.
4. Screw hose to hose holder (7).
5. Mount gun covers to the gun again.
To cabinet:
1. Push bared part of product hose (5) approx. 1.25 m; 4.1 ft through the opening as far
as the mounting plate (12).
2. Fasten mounting plate (12) to grounding screw with knurled nut (4).
3. Screw stripped end of product hose (5) to product connection (16) with union nut (6).
Counterhold with a wrench when tightening.
Two automatic guns: Observe the notices provided in Chapter 5.8.
ORDER NUMBER DOC 2369735
83