Table of Contents
Advertisement
VERSION 02/2018
OPERATING MANUAL
10 REPAIRS
10.1 REPAIR STAFF
Repair work should be undertaken carefully by qualified and trained personnel. They should
be informed of specific hazards during their training.
The following hazards may arise during repair work:
− Health hazard from inhaling solvent vapors
− Use of unsuitable tools and aids
A skilled person must check to ensure that the device is in a reliable state after it is repaired.
Carry out function test in accordance with Chapter 11.
10.2 SAFETY INSTRUCTIONS
Before a Repair
− Flush and clean the system
DANGER
Incorrect maintenance/repair!
Danger to life and equipment damage.
Only a WAGNER service center or a suitably trained person may carry out repairs and
replace parts.
Only repair and replace parts that are listed in the "Spare parts" chapter and that are
assigned to the unit.
Before all work on the device and in the event of work interruptions:
− Relieve the pressure from the device.
− Secure the spray gun against actuation.
− Switch off the energy and compressed air supply.
− Disconnect the control unit from the mains.
Observe the operating and service manual for all work.
After a Repair
− Carry out safety checks in accordance with Chapter 8.2.3.
− Put the system into operation and check for leaks as described in Chapter 6.8.
− Function test in accordance with Chapter 11.
In accordance with DGUV regulation 100-500 Chapter 2.29 and Chapter 2.36:
− The liquid ejection devices should be checked by an expert (e.g., WAGNER
service technician) for their safe working conditions as required and at least
every 12 months.
− For shut down devices, the examination can be suspended until the next start-up.
ORDER NUMBER DOC 2366717
Chapter 8.1.3.
82
Advertisement
Table of Contents
