WAGNER AquaCoat 5010 GM 5020EAW Operating Manual page 80

VERSION 02/2018
OPERATING MANUAL
Faults are indicated by the "Fault" LED (24). In addition the error number is shown in the
display (27). If a fault occurs, the high voltage is switched off immediately. The user can
only continue to work once the fault has been remedied and acknowledged with push
button "Service" (25).
Code
Malfunction
display
E11 Ground monitoring
E12 No coil current/cascade
interrupt
E13 Coil current too big
E21-E25 Exception error
E30 Door switch
E40-E43 Gun communication
faulty
E60 Password error
ORDER NUMBER DOC 2366717
24 25
80 100
60 80
R1
40 60
20 40
R2
10 20
kV µA
R3
Cause
– Grounding cable is interrupted.
– Gun is not connected.
– The cascade is not connected.
– Cascade is interrupted
defective
– The cascade is defective.
– Hardware defect has occurred.
– Door open.
– Door switch defective.
– Gun cable defective.
– Operating unit of spray gun
defective.
– Control unit defective.
– Password not set.
27
POWER
POWER
0 1
AquaCoat
B_03505
Remedy
– Check/replace gun cable.
– Check/replace gun.
– Connect gun.
– Connect the cascade.
– Check/replace cascade.
– Check/replace cascade.
– If problem persists, contact the
WAGNER Service Department.
– Close door.
– Check/replace door switch.
– Check/replace gun cable.
– WAGNER Service Department.
– WAGNER Service Department.
– Password to be set by Service
Center.
80